Back to Blog
Ultraedit 16.005/9/2023 You must connect the SX-PY serial port labeled SERIAL-DCE to the PC (using a straight cable with at least TX, RX, GND and DTE): PYO) you must upload it on the modem using the AT commands. If you need a start guide or documentation about the Pyhton language you can start from the following addresses: If you want you can also pre-compile the script to speed up the execution: the how to is available at the address How to compile Python scripts for the Telit module. The Pyhton language is interpreted and does not need a compiler: we must only write our script in a text file, save it with the. To start working with out SX-PY we dont need any particular tool: the only useful software are a good text editor (like Ultraedit and a serial console like Hyperterminal. 9 poles flat cable with female DB9 connector.To use all the test scripts described in this article you need the following hardware: With the GPS feature we can write a powerful geographic localizer in a minute! The SX-PY can be equipped either with GM862-PY engine or GM862-GPS engine that embeds a SiRFstarIIIâ„¢ GPS receiver. Power Led, Battery Charge Led, GSM Led, RF data Led and Test Led.1 host for ER400TRS serial radio module ( How to for SX ARM Linux).1 FLEX expander for SX16B board ( SX16B - IN/OUT expansion board) or FLEX boards to extend the number of input and outpus.RS232 serial line for uploading the scripts.GPS Receiver (available only with GM862-GPS module).Residual battery level available in Pyhton script via AT interface.Connector for battery backup (not included) with charge circuit.In the following the main features are listed: ![]() ![]() In a little space of 156x85 mm we found the GM862-PY modem (not included), a complete switching power supply section with battery backup, the debug serial line, the communication serial line, input and outputs lines. The SX-PY board has been developed to fully unleash the power of Telit Python modem engines In this article we will provide a quick start guide for SX-PY with full source code Tags: - Domotica - How-To - Python - Schede Area SX - Telecontrollo . How to use the SX-PY board Publication Date: 17-01-2007 | Versione Italiana | English Version Search Area SX site Back to: Home Page Articles Remote Control SMS How to use the SX-PY board
0 Comments
Read More
Leave a Reply. |